close
close

How To Make A Pillow Cover With Zipper And Piping

How To Make A Pillow Cover With Zipper And Piping. Sew the cut fabric around the piping cord. Draw a line from the edge of the zipper to the edge of the pillow, 1/2″ down from the top edge, on each side of the zipper.

Throw Pillow Cover Sewing Tutorial (A Howto for Invisible
Throw Pillow Cover Sewing Tutorial (A Howto for Invisible from www.pinterest.com

I recommend cutting your first square to be the same size as your pillow insert, then when you add the 1/2 seams your pillow cover will be 1 smaller than your pillow insert creating a fluffy, overstuffed look. Cutting the fabric corners a couple of times will allow the piping to lay flat against the pillow font and will make it easier to sew smoothly. You can trim these off later.

1 1/2 X 90 Strip For The Piping.

Sew the cut fabric around the piping cord. I used berkshire fabrics from walmart in the upholstery and curtain fabric section. Start the piping in the middle of an edge (rather than at the corners).

Cut A Triangle Off The Corner Of The Piping To Make It Go Around The Corner More Smoothly.

Usually to sew in an invisible zipper, i baste the two pieces of fabric together first at 1/8″ further out from the. Sew along the line you drew with a straight stitch. The zipper is easy and straightforward, but not so much the piping.

See also  Urgent Care With Ultrasound Near Me

Then Baste Across The Top Between The Two Lines.

Adding zippers to any craft project can be daunting, but with the right instructions, it is not that difficult to make a pillow cover with a zipper.[4] however, you must know how to use a zipper foot and machine. This video tutorial demonstrates how to construct a throw pillow with piping sewn along the edges. You will need to use your zipper foot to sew right up against the piping.

Then Lay The Cover Front And Back Facing Each Other (Nice Side On The Inside).

You might want to use a chopstick or turning tool to poke out the corners to be straight, if necessary. Pin the zipper in place all the way down the length of the zipper, ensuring the coils stay along that crease line. How to make a pillow or cushion cover with piping & zip ️ diy home decor.

Round The Corners By Clipping Their Edges And Align The Cords, So They Meet Before Basting In Place.

Pin the zipper (teeth side facing out) to the bottom fold of the cover back. I recommend cutting your first square to be the same size as your pillow insert, then when you add the 1/2 seams your pillow cover will be 1 smaller than your pillow insert creating a fluffy, overstuffed look. Turn the pillow cover right side out.

Related Posts

Leave a Reply

Your email address will not be published.