close
close

How To Remove Smoke Detector Cover First Alert

How To Remove Smoke Detector Cover First Alert. If your alarm is hardwired, turn off power. The latch to open the battery compartment is located on the side of the smoke alarm.

Smoke Alarm Remove Cover & Replace Battery BROOKS
Smoke Alarm Remove Cover & Replace Battery BROOKS from www.youtube.com

Test the wires with a tester to ensure no power is coming through them, then start pulling the wires and connector away from the detector to separate them. Remove the battery from the smoke detector (if there is a battery). Unlock an alarm's mounting bracket.

You Can Also Clean It By Wiping That Sensor Using A Cleaned Cotton Cloth Dipped In The Alcohol Or Use A Cleaning Solution Of The Lens.

You may need to remove the device, first, or just slide away from the battery compartment cover. If playback doesn't begin shortly, try restarting your device. Press and hold the “test/silence” button on the side of the detector for 10 seconds.

Once Done Put The Cover Back On It.

Insert a flathead screwdriver between the mounting bracket pin and the mounting bracket. Remove the detector from its mounting bracket and unplug the power supply. Push the locking pin through the hole near the battery drawer on the back of the smoke alarm.

If Playback Doesn't Begin Shortly, Try Restarting Your Device.

Remove the old batteries and press the test/silence button for 15 seconds. Hold the mounting bracket against the ceiling (or wall) and make a mark at the center of each of the mounting slots with a pencil. See “limitations of smoke alarms” for details.

Remove The Fuse Or Flip The Switch To Deactivate The Alarms.

You may need to unscrew the screw connected to the wall. It should stay by itself, but if it doesn’t, wrap a large rubber band around it. Watch our installation video to learn how to replace hardwired alarms with new first alert/brk alarms.

See also  How To Remove Smoke Detector Cover Kidde

With The Battery Removed, Press And Hold The Test Button For 15 To 20 Seconds.

Remove the detector by unscrewing the screw that attaches it to the mounting plate on the wall or ceiling. Watch our installation video to learn how to replace hardwired alarms with new first alert/brk alarms. How do you turn off a first alert smoke alarm?

Related Posts

Leave a Reply

Your email address will not be published.